MANUAL FOR USING THE AQUA - BOY

Manual For Using The Aqua - Boy

1. CHECK THE BATTERY FIRST

If the Pointer reaches the red zone as the picture, means the electricity is good. Otherwise, replace the battery if the pointer not reach on red zone.

2. CALIBRATION 

Calibration Value ( 70 )

1.The Calibration Electrode has a calibration value, which marked on the electrode. (Different calibration electrode may have different value).

2.Connect the “Calibration Electrode” to the Aqua-Boy and push white button.

3.Display on the Auqa-Boy should show exact figure as the calibration electrode’s value.

4.If there is difference with Aqua-Boy display and the calibration electrode, the Aqua-Boy may have problem. Return it to supplier for checking. 

3. Connect the Universal Electrode Holder to one end of the cable &  Connect the other end of cable to aqua boy meter

4. Use this electrode for  fabric / garment surface & Put the electrode surface to the garment pull the white button and read the data

Measure the garment on top and bottom area if garment have inner / lining measure also lining on top and bottom area ( see the form report for detail )

5. HOW TO ACESS THE DATA

1. After put the electrode surface on garment and pull the white button the pointer will read data

2. The readings obtained on the upper centesimal scale are converted from the readings of lower scales. By doing this, users are able to use the Comparison Table to tell the moisture content of the fibers other than wool, rayon or cotton

3. To easy access the data pls use below chart using Maximum acceptable upper centesimal scale  as per fabric content sample checking

6. How to calculate the maximum moisture content of blended fiber

7. For comparison of fabric content pls use as the below tabel  

8. For comparison of fabric content pls use as the below tabel